Home > Produtos > Energia Solar > Inversores > Outback
   
 
Outback

FX Series

The OutBack FX series is a modular "building block” sine wave inverter/charger that can be used for both small and large power systems. Each OutBack FX inverter/charger is a complete power conversion system - DC to AC inverter, battery charger and AC transfer switch.

Additional FX inverter/chargers can be connected at any time in either parallel (120 VAC), series (120/240 VAC), or three-phase (120Y208 VAC) configurations. This allows a system to be tailored to meet the specific power conversion requirements of the application, both at the time of the installation and in the future. The OutBack FX series is also available in export versions with 230 VAC, 50 hz output that can be connected in parallel (230 VAC) or in three phase (230Y400 VAC) configurations.
Faça o download dos ficheiros em formato PDF com a descrição deste produto.

Mate
SYSTEM MANAGEMENT REMOTE MONITOR AND CONTROL

The OutBack MATE is a complete system controller and display for both the OutBack FX2000 inverter/charger and MX60 MPPT PV charge controller.

It provides a display of the operation as well as allows control and adjustment of the setpoints.

The OutBack Mate also coordinates the operation of the entire system to maximize performance and to prevent multiple products from conflicting.
Faça o download dos ficheiros em formato PDF com a descrição deste produto.

MX 60
MPPT CHARGE CONTROLLER

The OutBack MX60 Maximum Power Point Tracking (MPPT) charge controller enables your PV system to achieve its highest possible performance.

Rated for up to 60 amps of DC output current, the OutBack MX60 can be used with battery systems from 12 to 60 vdc with PV open circuit voltage as high as 125 vdc.

The MX60's setpoints are fully adjustable to allow use with virtually any battery type, chemistry and charging profile.
Faça o download dos ficheiros em formato PDF com a descrição deste produto.
topo